Flexible LED Strip Tape, Exterior, 24V, Blue, 20' w/ Wire Leads

Bookmark This Page

Tell A Friend

Rate This Product

This version of our popular linear LED strip tape product uses brighter SMD LEDs for higher ambient illumination. Unlike the standard strip tape product, this version is encased in a UV resistant, clear silicone jacket and mounts with Flexible Mounting Straps (sold separately). This product is suitable for wet locations and will resist cracking and/or discoloration from harmful UV rays. For interior installations, we recommend using our Interior HO Strip Tape which has a clear epoxy coating and is installed with 3M self-adhesive tape (supplied). The thin diameter and low profile form factor allow this product to be installed in areas too confined for traditional rope light. Each section comes with wire leads so your LED Strip Tape is ready to connect to your DC power source. If required, this HO Flexible LED Strip Tape may be cut to suit every 4" (12V version) or every 6" (24V version), being careful to seal the cut end with the End Cap (sold separately). All our LED strip tape products provide homogenous, uniform light distribution without shadows or hot spots and are a great way to enhance the lighting in your living space. Outdoor applications include overhangs, cockpit lighting, exterior valance, sign back-lighting, etc.

Note:
This product performs optimally with constant voltage at or near the specified voltage input. It is sensitive to over-voltage and transient spikes, therefore long term performance is dependent on the input voltage provided. For installation on boats, a power conditioner is recommended for maximum life of the product.
See Imtra Power Conditioners here.

Features & Benefits:

• 95% brighter than standard Strip Tape (24V version)
• Flat profile
• UV resistant silicone cover
• Wide angle SMD LEDs
• Very low power consumption

**Special Note for Households or Yachts with Line Voltage**
All versions of our low voltage (12VDC or 24VDC) Flexible LED Strip Tape is designed for hard-wire DC hook-up (i.e., from DC power supply or battery source). If stepping down voltage from a 120/230V source, a standard low voltage AC transformer will damage the product. You must use a DC power supply or a voltage-regulated LED converter for this purpose.